User manual

13
Info SE-3 Setup Operate Riding
Tips
Battery Maintain T-shoot Warn Contact
Index Schedule
Drive/Electrical System
The SE-3 Patroller drive system consists of dual motor controllers and motors,
one for each rear wheel (Figure 4). The drive system and electrical system are
activated by a "power key," similar to an automobile's "ignition" key.
There are five conditions a rider must ensure before the SE-3 Patroller Drive
System is enabled:
• Power Cord must not be plugged in to the Charge Port
• Rider must be standing on the Rider Platform/Rider Detect Mat
• Power Key must be turned to ON
• Throttle must be at zero (not activated)
• DRIVE/STANDBY mode switch must be set to DRIVE
WARNING
Always set the DRIVE/STANDBY mode switch (p. 24) to STANDBY when the
vehicle is not being driven.
Motors
Each rear wheel is independently driven by a high-speed brushless electric
Motor that is quiet, efficient, and does not require periodic maintenance
to replace consumable parts. Each Motor is microprocessor controlled to
precisely regulate drive motion. Motors are serviceable only by Segway
trained and certified technicians.
Figure 4: Motor/Motor Controller Location (Under Rider Detect Mat)
Motor Controllers
Motors