Specifications

Basic Rider Optimization Training for the Segway HT Page 81 of 106

Instructor Guide and Participant Workbook Rev 3.5i - January 2004

Replacing the Fixed Grip

Tools Required: 5.0mm hex wrench, torque wrench

Before you begin:

> Make sure Segway HT is shut down and

not plugged into an AC outlet.

> Do not use the Parking Stand to support

the Segway HT while performing this

procedure. The Parking Stand is not

designed to withstand the forces that may

be generated. Instead, support the

Platform with an object so that you have

easy access to the Handlebar.

Directions:

Removal Instructions

1. Remove the fastener at the end of the

Handlebar on the Fixed Grip side using a

5mm hex wrench.

2. Slide the Fixed Grip off of the Handlebar.

Installation Instructions

Replace all old components, including

fasteners, with the materials included in this

kit

3. Orient the new Fixed Grip so that the key

on the inside opening aligns with the

groove on the Handlebar, and slide the

grip all the way on.

4. Thread in the new fastener and torque to

6.8 N-m with a 5mm hex wrench.