Specifications

Basic Rider Optimization Training for the Segway HT Page 77 of 106

Instructor Guide and Participant Workbook Rev 3.5i - January 2004

Replacing the Mat

Tools Required: none

Before you begin:

Make sure Segway HT is shut down and not

plugged into an AC outlet.

If Segway HT is an e Series, you must first

remove lower cargo bags and structure.

Directions:

1. Lift Mat off Platform. For i and e Series

models only, pull both “ears” of the Mat

inward, out of fender channels.

2. Before installing Mat, make sure top of

Platform and bottom of Mat are clean, dry,

and free of debris.

3. Place new Mat on Platform and press down.

4. For i and e Series models only, press

ears back into the fender channels.

Securing or Replacing the Front Trim

Tools Required: none

Before you begin:

Make sure Segway HT is shut down and not

plugged into an AC outlet.

Directions:

1. To remove the trim, pull from the bottom and

lift up.

2. If you are replacing the trim, peel the old

hook-and-loop fastener pad from the CSB,

and install the new adhesive-backed hook-

and-loop fastener pad.

3. Line up the hook-and-loop fastener. Match the

two tabs on the top of the front trim with those

on the CSB and lower trim back into place.

4. Use thumb pressure in areas where trim is still

loose.