Specifications

Basic Rider Optimization Training for the Segway HT Page 43 of 106
Instructor Guide and Participant Workbook Rev 3.5i - January 2004
© Segway LLC 2002 P/N 1707100001aa
Normal Operation
The following Display icons should appear each time you power on your Segway HT.
Display Icon Definition User Response
Startup test being performed. (All
segments should be displayed,
with no backlight).
Wait before attempting to use the Segway
HT.
Segway HT is in Power Assist
Mode (full battery charge level
indicator shown).
Do NOT attempt to step on the Segway
HT. It is not in Balance Mode. Rotate
Steering Grip to move the Segway HT
forward and back.
Segway HT is in Balance Mode
(full battery charge level indicator
shown).
You may step on and ride the Segway HT.
Segway HT is shutting down
(approximately one-half battery
charge level indicator shown). This
icon should only appear when you
power off.
Do not attempt to power on until orange
backlight disappears. (In cold weather, it
may take several seconds for this icon to
disappear.)
Error Conditions During Startup
If you attempt to power on your Segway HT, but the Segway HT detects a condition that precludes
power on, one of the following icons will appear in the Display. (The system fault icons described on
pages 45 may also appear.) All of these icons are red. You may clear these conditions with the
appropriate User Response described below. Do not attempt to step on the Segway HT until you
have cleared the error condition and you have confirmed that the Segway HT is in Balance Mode
Display Icon Definition User Response
The Key being used to start this
Segway HT does not contain the
correct security code.
Restart using correct Key. If condition
continues, contact Segway at
[e-mail] or call
1-866-4SEGWAY (1-866-473-4929).
The Segway HT is plugged in.
Unplug the Power Cord and, if the Segway
HT has powered off, power on again.
The Battery Packs are too low to
allow safe operation of the Segway
HT.
Charge the Battery Packs; then attempt to
power on.