Specifications

Basic Rider Optimization Training for the Segway HT Page 103 of 106

Instructor Guide and Participant Workbook Rev 3.5i - January 2004

Match the number in the illustration to the description below:

42. To straighten the

Handlebar, loosen the

Control Shaft Clamp

bolt ________(7)

that holds this clamp

together,

43. Tap the Mode Button

________(1)

to change from Power

Assist to Balance Mode

or hold for 2-3 seconds

to power down.

44. Disconnect the Control

Shaft ________(8) from

the Base, to check the

Control Shaft Cord

connectors.

45. If your Tire/Wheel

assembly wobbles,

check the Wheel Nut

________(6)

46. Insert the Control Shaft

into the Control Shaft

Base ________(4) after

you have checked your

Control Shaft cords.

47. Twist the Steering Grip________(2) left and right to turn, when you are in Balance Mode, or

to power the wheels forward and backward when you are in Power Assist Mode.

48. When you are stepping on, hold onto the Fixed Grip ________(9) and the non-twisting end

of the Steering Grip.

49. Adjust the height of the Handlebar by loosening the Height Adjustment Collar ________(3),

raising or lowering the Control Shaft, and then tightening the Height Adjustment Collar.

50. To remove a Battery Pack ________(5), tip the Segway HT to provide access beneath the

Platform, unfasten the four 3mm screws, and slide the Battery Pack straight off the chassis.