Instructions / Assembly

Part J.
SAFETY INFORMATION - OPERATIONS
Before performing a leak test, be sure:
1. ) DO NOT press the Igniter.
2. ) You are in a spacious outdoor area.
Connect the Propane Gas tank to the Regulator (12 /19) and turn the Valve (22) on the unit to the “OFF”
position.
Brush soap and water mixture onto all connections.
Turn the gas supply on; if extra large bubbles form on any connection there may be a leak. If you smell
gas or a leak is discovered, IMMEDIATELY turn the gas valve off, disconnect Propane Gas tank.
Do not use the appliance until the leak is repaired
The Fire Table / Column has a Door. Remove and leave it on the floor. Inspect the Gas Hose (12) before
using the Fire Table / Column.
If there are signs of wear or abrasion on the hose, you must replace the Gas Hose (12). The Gas Hose
must be supplied directly by manufacturer.
Lava rocks / pumice stones could pop up and strike somebody’s face during the process of lighting this
unit.
Stand away from the Fire Table / Column for the initial 20 minutes after igniting.
Observe flame color and flame height when the
Fire Table/Column after being lit :
1.
) Flame color should be yellow / blue.
2.
) Flame height burns at 2 - 10 inches high.
Wait 10 minutes after extinguishing flame prior to replacing a lid (if applicable) or protective cover onto
the Fire Table / Column.
2inchesto10inches.
17