Owner`s manual

73
www.seuservice.com
FIG. 11. 2 b
● Loosen the 2 hexagon socket screws on the Gear Holder and remove the Gear Holder.
● Remove the nut securing the VR Bracket, then separate the Volume from the VR Bracket and
replace it.
● Remove the connectors.
● Remove the 2 screws securing the VR Bracket and remove the entire Bracket and Volume.
This procedure requires the following tools: Philips screwdriver for the M4 screws, 2 mm
hexagonal wrench, 11—12mm monkey wrench, nipper, cutter, wire stripper, soldering iron and
industrial dryer.
VR BRACKET
CONNECTOR (1)
RED 3P
PHOTO 11. 2
REPLACEMENT PROCEDURE
SCREW (2)
M4×10, w/flat & spring washers