Owner`s manual

93
www.seuservice.com
TABLE 18. 2
No response from
Steering (Servomotor).
Steering (Servomotor)
is week in its force
feedback.
Unsatisfactory Accel and
Brake operation.
Start button and Change
View button input does
not work and they do not
flash.
Start button and Change
View button input works,
but they do not flash.
Failure of the network
play.
Failure of power-on checking
procedure.
Faulty connector connections.
Thermal element in the Servodriver is
operating.
Momentary overload caused a fuse on
the Servodriver to blow.
Aging of the force feedback
mechanism.
Incorrect volume setting.
Faulty Volume attachment or adjust
gear alignment.
Faulty connector connection.
Failure of the volume.
Faulty connector connections.
Unverified settings or operation.
The lamp is burnt out.
Network play is wrongly set.
Communication cables are
disconnected.
Communication cables are wrongly
connected.
Damage of communication cables.
Reconnect the power and complete a power-
on checking procedure.
Check the connections for the connectors
between the Game Board and Servodriver and
between the Servodriver and the Servomotor.
Occurs when the internal temperature reaches
70°C (158°F) and corrects automatically when
the unit cools.
Contact the company from whom the unit was
purchased.
Reset in the Test Mode.
Adjust the volume value in the Test Mode.
Adjust the volume attachment and verify in
Test Mode.
Check the connections for the Accel and
Brake connectors and the connectors between
the Accel, Brake and Cabinet.
Replace the volume.
Check the connections for the connectors
between the I/O Board, the Cabinet and the
Control Panel and those inside the Control
Panel.
The Start button only flashes when Free Play
is set. Check the operation in Test Mode.
Replace the lamp.
Reset correctly.
Reconnect the cables.
Reconnect the cables correctly.
Replace the cables. Contact the company from
whom the unit was purchased.
PROBLEM CAUSE COUNTERMEASURES