User`s manual

ST-174-R2-090294
SEGA Enterprises, Ltd.
(RDJ, 7/18/94)
22
E7000 Interface Cable
Figure 2.9 EVA board connections
Next, connect the following cables, which are attached to EVA board, to the
connector on main mother board.
See the manuals belonging to the EVA board or Debugger for the installation and
operating method of the EVA board itself. An example of how to set EVA board
short pins is shown below. For more information about short pin settings, see
"Short Pins" in the SH-2 small-size EVA board user's manual.
Example of Short Pin Setting Method (for Programming Box / Graphics Box)
No. 10 PSCB Clock setting → PSCB2 (J14=2-3 short, J15=1-2 short)
Other
→ J1~J13=OFF
Caution:
• When the EVA board is not set correctly, debugger may not start or it may operate erratically.
• Check that this connector is firmly connected if EVA board can not access the I/O of Target Box
and memory at all.
Note after connecting
In EVA board user's manual, it states that the EVA board is connected to the Target
Box with screws. Actually, this is not possible because of the Target Box casing.
Therefore, the Target Box should not be sent with the EVA board connected. Also,
extra precautions must be taken when moving within a room.