User`s manual

ST-174-R2-090294
SEGA Enterprises, Ltd.
(RDJ, 7/18/94)
21
Connecting the EVA Board
Attach the EVA board to the connector for connecting the SH-2 board/EVA board.
See Figure 2.8 for the connector location.
Main Board
<Slave>
<Master>
PGA Sockets for ICE Connection
Connectors for SH-2 Board/EVA
Board Connection
Outside Target Box
SH-2 Board Points of Connection
Connectors for SH-2 Board/EVA
Board Connection
Figure 2.8 Points of connection for EVA board
Next, refer to the information below to properly connect the EVA board power and
Reset cables.
• EVA board power cable
EVA board side connector CN8 (the lowermost board)—Connector to the Target Box CN10
• EVA board Reset Cable
When Eva board is connected to the Master Side
EVA board side connector CN8 (the uppermost board)—Connector to the Target Box CN5
When Eva board is connected to the Slave Side
EVA board side connector CN8 (the uppermost board)—Connector to the Target Box CN4
One end of the branched EVA board power cable is already connected to the SH-2
power supply in CN10. Therefore, the other unconnected power cable should be
connected to the EVA board power connector. Close the ICE/EVA board SH-2 plug-
in port cover, secure with srews at two locations, insert the interface cable that is
attached to EV7000 from the cover window, and connect to the EVA board
connector. See Figure 2.9.