User`s manual

ST-174-R2-090294
SEGA Enterprises, Ltd.
(RDJ, 7/18/94)
15
Removing the SH-2 Board
Remove the SH-2 board from the main board when the SH-2 board is connected to
the SH-2 board/EVA board connector on the side where the ICE is. Figure 2.6 shows
the SH-2 board connecting locations.
Note: A SH-2 board, under standard shipping conditions, is mounted in the Programming Box on the
slave side and in the Graphics Box on the master side. A new SH-2 board should be purchased
if you want to add one to a side without the SH-2 mounted to it. For more information, please
contact SEGA.
For details, refer to “chapter 4 support center.”
ICE Connection
The 171-pin PGA socket is visible when the SH-2 board is removed.
Main Board
<Slave> <Master>
PGA Sockets for ICE Connection
Connectors for SH-2 Board/EVA
Board Connection
Outside Target Box
SH-2 Board Points of Connection
Connectors for SH-2 Board/EVA
Board Connection
Figure 2.4 Location of PGA socket for ICE connection
Install attached ICE PGA to ICE POD tip PGA plug while care is paid to the
orientation.
Next, insert the PGA plug at the end of the ICE POD into the PGA socket on the
main board as shown in Figure 2.5.