Specifications

1-18 Programmer’s Guide Sega
Psy-Q Development System
Installing the Windows ’95 Debugger
Installation Instructions
Note: You will need to know your Psy-Q SCSI card hardware resource settings to
complete installation.
Note: The Compiler, Assemblers and Linkers must have been previously installed
within DOS.
Note: Do not install PSYBIOS.COM as this and RUN will not be needed with the
Windows ‘95 Debugger.
Installing Automatically from Floppy Disk
Ensure there is at least 1.5mb free on your C drive and in addition, 2.5Mb free on the
drive where you will be installing your software.
1. Read setup.txt.
2. Run the program setup.exe by double-clicking on it using an explorer window.
3. Select ‘Yes’ to start the installation.
4. Setup will unzip and launch the Psy-Q for Windows ’95 setup program
(pqsetup.exe). On-line help is available throughout the installation process.
5. If this is the first installation of the Debugger, confirm the specified licence
conditions.
6. Specify or confirm the directory in which you wish to install the Debugger.
7. Depending on the type of installation, specify the settings for the DE Board or
SCSI card.
8. After installation is complete, close pqsetup and setup will delete the temporary
files it installed on your hard disk.
Installing Manually
1. Unzip the file pp100zip into a temporary directory.
2. Run the program pqsetup.exe.
3. Select psxp_1.pqp and continue with the installation.