Specifications

1-12 Programmer’s Guide Sega

Psy-Q Development System

Downloader Installation

If you have correctly connected the target interface to your Psy-Q PC SCSI card,

once you have installed the Psy-Q software you should be able to confirm

communication with the PC by executing the Psy-Q RUN program (with no

parameters).

You must also have installed PSYBIOS correctly before you can execute the RUN

program. RUN will establish a connection to the target system and display the ID

code of the interface firmware. If no downloaders have been installed, a message

should appear something like:-

RUN.EXE Executable/Binary file downloader version 2.30

Target 0 is SH2 - SATMSTR1.01

No file to process

Before you start development, you will need to install the full downloader provided

on the Issue Diskette. This file is called SATxxx.cpe, where the xxx denotes the

current version number. This downloader is installed into the adapter by using the

RUN command.

For example:

RUN SAT201.CPE

The downloader will be kept battery backed in memory until another version of the

downloader is installed. To check everything worked properly, just execute RUN

again. It should report the correct version of the new downloader just installed.

Assuming this all works correctly then your installation is complete and you can

proceed to experiment with Sega Saturn software development...