Specifications

16-10 Programmer’s Guide Sega
Psy-Q Development System
Configuring Your SCSI Card
If you are installing a Full Release for a SCSI Target, you must specify the settings
for the SCSI Card.
4 Enter appropriate values to the dialogue box displayed during the Set-up program.
SCSI Card Settings Dialogue Box
1.
Specify a Port Address and IRQ value by clicking on the down arrows and
selecting as appropriate.
2.
Click .
The installation is now complete.
IMPORTANT: Port Address and IRQ values must be correct for the Debugger to
work. If they are incorrect or another device is configured to use
similar settings, the programs will not work.
Note: The IRQ value can be set to 0 to run without interrupts. However, this is only
recommended for troubleshooting since running without interrupts will
seriously impair the performance of the system.