Specifications

Saturn Psy-Q Installation 1-3
Psy-Q Development System
Installing the PC Interface
The Psy-Q PC Interface board should be fitted in to an empty 16 bit slot in the host
PC. The host must be an IBM PC-AT or compatible, running under MSDOS 3.1 or
better.
If no 16 bit slot is available, the board will also fit into an 8 bit slot. However, this
causes some degradation in speed.
Prior to fitting, the 3 banks of dip switches should be checked and configured as
required. It is likely, however, that the factory setting will suffice. They are described
below.
The Psy-Q PC Interface Board
CAUTION: This board is sensitive to static electricity; hold by the metal support
bracket when handling.
2 Active
Termination
Resistors
SCSI
Controll
50 Pin
High
Density
SCSI
Connector
On Dip
1 2 3 4 5 6 7 8
On Dip
1 2 3 4 5 6 7 8
On Dip
1 2 3 4 5 6 7 8