Technical information

SEGA Confidential
10
5.2 Start and Quit
Once the Virtual CD Emulator starts, enter the following commands:
Step 4
C:MYDIR>VCDEMU∆JVC[ENTER]
The Virtual CD Emulator is launched and the screen is displayed.
Specified disk image files, CD structure data files, script files, and log data file
names are displayed on the screen. “No Log File” is displayed when no log data file
is specified. The Virtual CD Emulator at this point waits for key input for user
confirmation of the message. Pressing a key allows you to proceed to the next step.
Step 5
Press ENTER or ESC.
The program begins reading the files needed for execution. If read correctly the
following is displayed.
Open New File = ****.dat
All Data has been Read
PAUSE2
[Result]
“Direct” should be seen in the display of the dialog box operation mode in the upper
right of the screen, meaning that the “Direct DOS File Access” operating mode is in
effect. Work is done on the target box from this point.
Step 6
Launch the SATURN program from the ICE.
• Insert Disk 1 into Drive A of the PC that controls the ICE.
• Halt the ICE by pressing CTRL-C, and reset with the following commands:
:rs[ENTER]
:g[ENTER]
• Wait a moment after the SEGA SATURN logo display is finished.
:ctrl-C
• Load the program.
:<A:JVC1.INI[ENTER]
• Run the program.
:g∆6002000
Step 7
Check to make sure that the program starts normally, and that "VIRTUAL CD
CHECK PROGRAM" is displayed on the SATURN's screen.
Step 8
Operate the pad according to the instructions displayed on the screen and make sure
that the CDDA playback demo finishes properly.