Operation Manual

UK-10
control (3) for a few seconds, "ON" and "00:00” appears on the display and the
HOUR digit flashes.(F1)
2. Press the SKIP/TUNE SEARCH (UP or DOWN) button (19,17) to adjust it.
3. Press the TIMER button again, the MINUTE digit will start flashing, adjust it by
pressing the SKIP/TUNE SEARCH (UP or DOWN) button.
4. Press the TIMER button once more to confirm and order TIMER ON time.
5. After adjusting "TIMER ON", "OFF" appears on the display and the HOUR digit
flashes.(F2)
6. Repeat the above steps 2 to 3, and then press the TIMER button once more to
confirm and order TIMER OFF time.
7. Now the "TUNER" appears on the display with flashing, adjust "TUNER, CD,
USB or SD CARD" by pressing the SKIP/TUNER SEARCH (UP or DOWN)
button.
8. Press the TIMER button again, the timer "VOL" indicator appears on the display
and flashes, adjust the timer volume high or low by pressing the SKIP/TUNE
SEARCH(UP or DOWN) button.
9. Each enable state as shown above will be cleared if the button is not pushed in
10seconds.
10. After adjusting "TIMER ON" and "TIMER OFF", press the TIMER button," "
appears on the display.
11. The unit will be switched on automatically at "TIMER ON" order and start
playing, the unit will be switched off automatically at "TIMER OFF" order.
Note: If the display shows "ERROR" while you set the "TIMER ON" it means both
"TIMER ON" and "TIMER OFF" to set the off time first.
EQ CONTROL
EQ shows the present sound tone. When you press the EQ button, the sound tone
changes as below:
SLEEP FUNCTION (BY REMOTE CONTROL)