Operation Manual

UK-9
BATTERY REPLACEMENT
When the battery become too weak, the operating distance of the remote controller is
greatly reduced and you will need to replace the battery
Notes: To maintain the accuracy and long life of the transmitter, do not press two or
more buttons simultaneously
If the remote control is not to be used for a long time, remove the batteries to prevent
possible damage through leaking batteries.
USING THE REMOTE CONTROLLER CORRECTLY
Point the remote controller at the remote sensor (6)
The functions of the button on the remote control are the same as the corresponding
controls on the main unit.
When there is a strong ambient light source, the performance of the infrared remote
sensor may be degraded, causing unreliable operation.
The maximum effective distance of remote control operation is about 5 metres (16.5
feet).
CLOCK SETTING
In the STANDBY mode:
1. Press and hold the MEM/C-ADJ. button(16) until the time display changes to
12-hour digit and will flash.
2. Press the SKIP/TUNE SEARCH(UP or DOWN) button (19,17) to adjust 12-hour
or 24-hour digit.
3. Press the MEM/C-ADJ. button (16) again, the HOUR digit will flash on the
display, press the SKIP/TUNE SEARCH(UP or DOWN) button (19,17) button to
adjust HOUR digit.
4. Press the MEM/C-ADJ. button once more, the MINUTE digit will flash on the
display, press the SKIP/TUNE SEARCH(UP or DOWN) button(19,17) button to
adjust MINUTE digit.
5. Press the MEM/C-ADJ. button again to confirm the time.
6. Each state as shown above will be cleared if the key is not pushed in10 seconds
TIMER SETTING
During in the STANDBY OFF/ON mode.
1. After adjusting clock, press the TIMER button on the unit (10) or the remote