Operation Manual

UK-11
CLOCK SETTING
In the STANDBY mode:
1. Press and hold the MEM/C-ADJ. button (7) until the time display changes to
12-hour (or 24-hour) digit and will flash.
2. Press the SKIP/TUNE SEARCH (UP or DOWN) button (12, 13) to adjust
12-hour or 24-hour digit.
3. Press the MEM/C-ADJ. button (7) again, the HOUR digit will flash on the
display, press the SKIP/TUNE SEARCH (UP or DOWN) button to adjust HOUR
digit.
4. Press the MEM/C-ADJ. button once more, the MINUTE digit will flash on the
display, press the SKIP/TUNE SEARCH (UP or DOWN) button to adjust
MINUTE digit.
5. Press the MEM/C-ADJ. button again to confirm the time.
6. Each state as shown above will be cleared if the key is not pushed in10 seconds
TIMER SETTING
During in the STANDBY OFF/ON mode.
1. After adjusting clock, press the TIMER button on the unit (8) or the remote
control (3) for a few seconds, "ON" and "00:00” appears on the display and the
HOUR digit flashes.(F1)
2. Press the SKIP/TUNE SEARCH (UP or DOWN) button (12,13) to adjust it.
3. Press the TIMER button again, the MINUTE digit will start flashing, adjust it by
pressing the SKIP/TUNE SEARCH (UP or DOWN) button.
4. Press the TIMER button once more to confirm and order TIMER ON time.
5. After adjusting "TIMER ON", "OFF" appears on the display and the HOUR digit
flashes.(F2)
6. Repeat the above steps 2 to 3, and then press the TIMER button once more to
confirm and order TIMER OFF time.
7. Now the "TUNER" appears on the display with flashing, adjust "TUNER, CD,
USB or SD CARD" by pressing the SKIP/TUNER SEARCH (UP or DOWN)
button.
8. Press the TIMER button again, the timer "VOL" indicator appears on the display
and flashes, adjust the timer volume high or low by pressing the SKIP/TUNE
SEARCH(UP or DOWN) button.
9. Each enable state as shown above will be cleared if the button is not pushed in
10seconds.