User Manual
6
The cleaning stops when the timer counts down to 00:00. If the unit needs to be
stopped before the timer runs up, press ON/OFF button.
NOTE: Do not run the cleaner continuously for more than one hour
3. Set temperature: Press “temperature-/temperature+”shortly at a time
means time increase/reduce 1℃ at a time, press and hold there means time will
increase/reduce by 1℃ . Usually, the best results are within 40℃ to 60℃.
4. After time and heat setting, press ON/OFF key to start both function. Press
“Heating” button “OFF”, the heating function will stop. The same for Ultrasonic
function.
5. Empty the tank and clean both the outside and inside of the cleaner with clean and
dry cloth for next use.
NOTE: Do not pour water out until it’s cooling, Hot water will hurt you and damage
the machine itself.
DIFFERENT WAYS OF CLEANING
Gennral Cleaning—
use only tap water. Use warm temperature about 50℃ .
Enhanced Cleaning—add few drops of standard washing up liquid,liquid soap, or
detergent into water, other non-acidic cleaning agents can also be used.
Extensive Cleaning—
removing tarnish, carbon & rust from non-plated metals, it is
recommended to use specialist cleaning solution in associated using ultrasonic cleaner.
The cleaning solution will deteriorate in effectiveness over time and use. It is important
to regularly change the fluid and carefully wash the inside of the cleaning tank in order
to preserve the effectiveness and longevity of the cleaner. Do not use corrosive or
abrasive cleaning products on the tank, which must be wiped down and dried before it
can be re-connected to the electrical supply.
NOTE: If the machine starts to spark, smoke, smell of burnt electrics or displays any
other fault the operator must immediately stop the machine, isolate the electrical
supply and contact the supplier. Continued use is dangerous.
WARNING : Strong acid or alkaline cleaning solution will cause corrosion, rust and
even puncture of tank or machine body. To overcome this problem, dilute to mild PH
solution or request for tank made of specific grade of stainless steel like SUS304.