User Manual

4
4) The more items that you place in your cleaning bath the less efficient it will clean.
It is not advised to overlap items. Always allow plenty of clear space between the
items.
5) Do keep the lid on during use. This will prevent splashes and reduce evaporation
of the fluid.
6) Never immerse the machine or power cord in water or other liquid.
7) DO NOT touch the power plug with wet hands, especially when inserting or
removing the plug.
8) DO NOT touch the unit if the machine has fallen into water during operation.
Remove the power plug from the socket first.
9) DO NOT disassemble the machine, except by professionals.
10) UNPLUG the power source while filling or emptying the tank.
11) DO NOT spray water or liquid over the device and the control panel
12) DO NOT operate the cleaner without proper grounding.
13) DO NOT place the device on a soft surface, where the vents could be blocked.
14) Always turn the heater off after using as leaving it on can cause the fluid to
evaporate and damage the internal components.
15) Upon completion of the cleaning cycle, turn the heater button off and isolate
the machine from the electrical supply.
16) Take care when adding or removing items from the cleaning tank as the fluid is
likely to be hot. Any displaced fluid must be dried up immediately.
17) In the event of failure/emergency, disconnect the mains supply by removing the
plug from the mains socket.