Use and Care Manual

to the starting temperature, pull down the pressure handle immediately.
Printing preparation: clean the surface of the transfer material with a cloth, the
transfer paper bonds surface of the transfer material, with a high temperature
adhesive tape fixed to the front facing material, place the material with the
head up, put it in the foam silicone board. If the pressure is not suitable, adjust
the height of the machine head.
Hint about poor printing images:
Subdued colors: uneven pressure or temperature is too low or time is too
short.
Fuzzy pattern: long time cause the ink to spread.
Matte pattern: excessive pressure or temperature.
Local fuzzy pattern: Uneven heat in the printing area.
Scar pattern: transfer time is too long.
Pattern color shades: uneven pressure or object uneven or transfer coating
uneven.
Sticker: temperature is too high or the coating is bad.
Read before operating:
Be sure to operate with safe ground wire !!!
Check the voltage before using it. Turn off the machine and cut off the power supply.
When using the machine, please don’t heat the machine without operating it for long
time . When finish transfer press, please turn off the machine.
When heating the machine, don’t touch the up heat plate in case of scald.
When you press the handle, if you feel the pressure is too much and hard to press it,
please adjust the using pressure by hand. Keep children away from the machine.
Setting Temperature & Time