User`s manual

SVR-500 Series
Network Video Recorder
User’s Manual
English
105
The UPS information should be obtained an displayed at the bottom
of the page after the settings are applied:
To enable network UPS support (NVR acting as UPS slave):
1.Goto“NVRSetup”>>“SystemOptions”>>“UPSCongurations”,
and check “Enable UPS Support” option.
2. Enter the IP address of the NVR running as UPS server. (The
NVR with USB UPS physically attached to)
*PleasemakesurebothNVRs(UPSserverandslave)areonthesamelocal
networktoensurethecommunication
betweenthetwo.
*PleasemakesurebothNVRsarepluggedintotheoutletsthatconnectto
theUPS.