User Instructions

7 / 17
Getting Started
To use the W600 Module, you need to use USB-to-Serial Tools to connect the RX/TX pins to your computer,
also you need to power this module with the 3.3v and GND pins.
!!!Note For mac, we found that some version of mac system can not recognize the on-board USB-to-Serial
chip CH330N, please check here for solution Mac os driver issue
We use the serial port tool sscom to send the AT command. You can use your favorite serial port tool, in case
you want to use sscom, you can download it Here.
What ever, please make sure you have checked the option AddCrLf, and set the baud rate to 115200
Tap AT+ then click SEND or press ++enter++ key to to check if the connection was successfully established.
AT+
When it returns +OK, you can use the AT command to control this module.
Create a SoftAP process
1- WPRT sets the wireless network card working mode to SoftAP:
AT+WPRT=2