Data Sheet

PK-1000 User Manual
- 7 -
Figure 7 Upgrade succeed
(4) Cut the power. Please make sure that BOOT0 is set as LOW voltage when
you want to re-power PK-1000 tag. If you need to set up anchor ID, please use
our host computer RLKit.
2.1.2 SWD upgrade
We don’t recommend you to upgrade through this method.
2.2 PK-1000 anchor code upgrade
2.2.1 SWD upgrade
We don’t recommend you to upgrade through this method.
Attention:
1. If there’s any malfuntion after upgrading PK-1000 tag, or the MCU
software (which communicates with UWB chip) in the PK-1000 anchor,
with SWD upgrade, we bear no responsibility for this situation.
3. RLKit manual
3.1 Connection
3.1.1 Serial ports
(1) Power PK-1000 tag, connect the system as following figure, and make
sure the Serial-port to USB Driver is installed in advance.