User Manual

6
Button
Function
A
Run/Hold
Choose to save current file
▲
Upward selection
▼
Downward selection
◄
（left/decrease）change setting parameters
►
（right/increase）change setting parameters
OK
Menu
Choose to save current parameter setting
NOTE：There are corresponding colors for items in Parameter Area and Measurement Area.
X Measurement Operation Instruction
1. Parameter Area Intro
Menu
Item
Function(Operate: Press ◄or ►)
A
AUTO/NORM/SINGL/NONE
Automation/Normal/Single
B
10mV-10V（1-2-5 stepping）
y-axis voltage per grid
C
×1/×10
multiple
D
1uS—2S（1-2-5 stepping）
x-axis voltage per grid
E
-Inp/Data/-Data/Inp+D/D-Inp/Inp-D/Off
Operation of 2 waveforms (Inp is
current waveform; D/Data is
previously saved waveform);Off is
hide Inp and D/Data waveform
F
Triggering Method: Falling edge
trigger, Rising edge trigger.
G
±80mV—±7.8V
Horizontal triggering range
H
/
Power supply by battery/ by USB
2. Measurement Area Intro
Item
Function Intro
Yn
Y-axis Function Setting
Xn
X-axis Function Setting
Tr
Triggering Function Setting
Me
Measurement Function Setting
Ex
Waveform Operation Function Setting
Fn
Save and Load Function Setting
Sn
Output Waveform Parameters Setting
Ca
Calibration Setting
3. Specific Parameter Intro
Choose the items in parameter area through “▲” or “▼”. Press “OK” to access parameter setting menu, use
“▲” or “▼” to choose the parameter item, and then use “◄” and “►” to change the parameter value of the place
where the cursor blinks.
（1）Annotation of Yn parameters