User Manual

13
（2）Measure peak-to-peak value of the signal source.
Please operate according to following steps:
Use “▲” or “▼” to choose Yn items in Measurement Area
Press “OK”
Use “▲” or “▼” to choose CursorV1
Use “◄” or “►” to adjust the position of CursorV1 to the crest
Use“▲” or “▼”to choose CursorV2
Use “◄” or “►” to adjust the position of CursorV2 to the valley
And get：△V=2.08V. i.e. the cycle of signal source, as shown in the image below:
3. Example Three：Save waveform image
Sometimes waveform images need to be archived or analyzed on PC platform.
Please operate according to following steps:
Use “▲” or “▼” to choose the Fn items in Measurement Area, press “OK”, use“▲” or “▼” o choose Save
Bmp, and then use “◄” or “►” to choose the file name on the lower right corner of the screen ,e.g.Save000.BMP，
as shown in the image; and then press“||” to save it to the built-in U disk.
Just copy the image to your PC, and you can analyze the waveform image.
V1
V2