User Manual

12
parameters that need analysis, e.g. Freq(frequency), Duty(dutyfactor), Vpp(peak-to-peak voltage)etc., the
measured value will be displayed at the lower right corner of the screen, as shown in the image below:
2. Example Two： Measure with Cursor
A cursor can be used to measure the time and voltage of the waveform very quickly.
（1）Measure the cycle of signal source
Please operate according to the following steps:
Use “▲” or “▼”to choose Xn items in Measurement Area.
Press “OK”
Use “▲” or “▼” to choose CursorV1
Use“◄” or “►” to adjust the position of CursorV1 to the crest.
Use “▲” or “▼” to choose CursorV2
Use“◄” or “►” to adjust the position of CursorV2 to the valley.
And get：△V=1.00mS i.e. the cycle of signal source. As shown in the image below:
Measured value
T1
T2