User Manual

11
（8）Annotations of Ca Parameters
Oscilloscope Calibration：Press A
XI Application Examples
1. Example One: Measure Simple Signal
Observe one unknown signal in a circuit, quickly measure & display the signal’s frequency & peak-to-peak value.
Please operate according to following steps:
Connect the channel probe to the detection point of the circuit.
Set the Channel mode as AUTO, adjust the (Horizontal) time calibration and (Vertical) voltage calibration,
make sure the signal displays clearly.
Adjust Threshol horizontal triggering position to make signal display stable.
Use “▲” or “▼” to choose Me items in Measurement Area, then press “M”, use “◄” or “►”to choose the signal
Cal Zero
Calibration without voltage
CalRange
Calibration with voltage
Restore
Master Reset