Data Sheet

ELECTRICAL PERFORMANCE／电器性能

5 PROTECTION FEATURE／保护特性

5.1 OVER－CURRENT PROTECTION／过电流保护：

The green mode power suply shall be hiccupped when any output operating in overload condition(set@ Max

load 120～ 200% ) under any line condition for an indefinite period of time.The power supply shall be self

－ recovery when the fault condition is removed.在任何时候任何输入条件，当输出操作在过载条件最大

电源的（120～200% ）时，电源供应器将进入打嗝模式，当故障被移走后，电源要能自动恢复到正常。

5.2 SHORT－CIRCUIT PROTECTION／输出短路保护：

The power supply shall be hiccupped and no damage shall occur when any output operating in a short circuit

condition under any line condition for an indefinite period of time.The power supply shall be self－recovery

when the fault condition is removed.在任何时候，任何输入条件下，当输出操作在短路情况下，电源供

应器将进入打嗝模式，当故障消失后，电源要能自动恢复正常。

6 ENVIRONMENTAL CONDITIONS／环境条件

6.1 OPERATING／操作条件：

The power supply shall be capable of operating continuously in any mode without performance deterioration

in the following environmental conditions.在下列环境条件下，电源供应器要能够连续操作在各种模式，

且不能造成性能的退化。

6.1.1 Ambient Temperature：0℃～40℃ 环境测度：0℃～40℃

6.1.2 Relative Humidity：10%～90% 相对湿度：10%～90%

6.1.3 Vibration：1.0mm, 10－25Hz，15 minutes per cycle for each axis (X, Y, Z)

6.1.4 Cooling：The power supply will operate with convection cooling.Blocking of vents must not cause damage to

The power supply.. 电源供应器将操作在对流冷却的环境下，即使将通风口阻塞电源也不允许有任何损

伤发生。

6.2NON－OPERATING／非操作条件：

The power supply shall be capable of witstanding the following environmental conditions extended periods of

time, without sustaining electrical or mechanical damage and subsequent operational deficiencies：电源供应器

要能够长期的经受下列的环境条件，且不允许有电气级机械方面的损伤和并发的操作的缺失。

6.2.1 Ambient Temperature：－30℃～70℃ 环境温度：－30℃～70℃

6.2.2 Relative Humidity：10%～90%相对湿度：10%～90%

6.2.3 Color of case and cable／外壳及线材颜色：Black／黑色

6.2.4 Vibration and Shock／振动和冲击

The power supply shall be designed to withstand normal transportation vibration per MIL － STD －

810D,method 514 and procedures X, as it s mounted in the chassis assembly and packed for shipping.电源供应

器装配及出货的包装设计，均要能承受正常运输的振动，并符合 MIL－STD－810D 方法 514 和程序 X。

EDITION

版本

PAGE

页码

4/9