User Guide

IoT into the Wild

Sensor Warm-up Time

The warm-up time denotes the amount of time it takes for the

sensor to attain its highest accuracy or performance level once the

voltage supply has been applied.

Digital input

Sets the type of input pulse.

Pull High: Valid when a rising edge is detected.

Pull Low: Valid when a falling edge is detected.

Digital Filter

When the pulse width exceeds 250 μs, which advised to enable it. It

is enabled by default.

Reboot to clear the

count

When a Datalogger restart occurs, the count is cleared to 0. It is

disabled by default.

Y= Ax + B

“Y”: It is the value Datalogger will upload.

“x”: It is the original counter value.

Factory A: Custom values that can be scaled up or down by

multiples of the “x”.

Factory B: A custom value that increments or diminishes the value

of the “x”.

By setting the values of A and B, you can calculate the desired

value. If only raw counter values are uploaded, set A=1 and B=0.