User Manual
Table Of Contents
- 1. Product Introduction
- 2. Quick Deployment Guide
- 3. Assemble the Device
- 4. Configure the Device to Connect to SenseCAP Cloud Platform
- 5. Add a Custom Sensor
- 6. Troubleshooting and Log Analysis
- 7. Do’s & Don’ts
User Manual
© 2008-2021 Seeed Technology Co., Ltd. All rights reserved. solution.seeedstudio.com
Page 7 of 45
Connect Sensor Hub to 3rd-party Sensors and Servers
1. Unpack, refer to the packing list and check whether there are missing parts.
2. Install the SIM card: Use the Allen Hex Key to open the cover of the device and insert the SIM card.
3. Install the antenna.
4. Download Sensor Hub Configuration Tool, connect the device (via port B6) to computer with a USB-to-TTL cable.
5. Install the driver, access the above-download tool, and power on the device by pressing the switch (B5). Then
configure the followings in the software:
1) Sensor information.
2) APN information.
6. Turn off the switch (B5) for 10 seconds and start it again.
7. Check the sensor data on the server.
8. Deploy the device.
1) Check and confirm the location for installing the device.
2) Install poles, brackets, and sensors, etc.