User Manual
Table Of Contents
- 1. Product Introduction
- 2. Quick Deployment Guide
- 3. Assemble the Device
- 4. Configure the Device to Connect to SenseCAP Cloud Platform
- 5. Add a Custom Sensor
- 6. Troubleshooting and Log Analysis
- 7. Do’s & Don’ts
User Manual
© 2008-2021 Seeed Technology Co., Ltd. All rights reserved. solution.seeedstudio.com
Page 31 of 45
Note: After you have configured the parameters, be sure to click Write.
5.2.4 Sensor Test
Tip: After configuring the parameters, make sure that the sensor is connected to the device port before powering
on. And if not, turn off the power and connect the sensor before re-entering the Sensor Configuration Interface.
Click the test button to see the test results: 5500(soil temperature value) = 26.88, 5501(soil moisture) =0.00, and
check if it is correct. If the values are abnormal, refer to the 7 section of the manual for analysis and debugging.
5.2.5 Check & Confirm Data’s Upload to the Server
When finishing the testing on the software, turn off Sensor Hub and the Sensor Configuration Interface.
（1） Uncheck " Enter configuration mode automatically on device's booted " .