User Manual
Table Of Contents
- 1. Product Introduction
- 2. Quick Deployment Guide
- 3. Assemble the Device
- 4. Configure the Device to Connect to SenseCAP Cloud Platform
- 5. Add a Custom Sensor
- 6. Troubleshooting and Log Analysis
- 7. Do’s & Don’ts
User Manual
© 2008-2021 Seeed Technology Co., Ltd. All rights reserved. solution.seeedstudio.com
Page 21 of 45
4.4.4 APN Configuration
⑤ APN, APN username, APN password: Type in your SIM Card’s APN information.
4.4.5 Read and Write button and Clear Data.
⑥ Hardware/Software version: You can view the version info of the device (readable only in working mode).
⑦ Read: After the Write configuration, click Read to check if the information is in effect.
Write: After modifying any parameters, you must click "Write" to save the information.
Clear Data: The device caches data when the network is poor or it’s disconnected. After reconnecting to
the network, it uploads the cached data to the server. Click "Clear Caches" to delete the data that has been
cached on the device.
Power on the Device
Before powering on the device, make sure the antenna and SIM card are installed, APN is configured. When
installing an antenna, make sure that the device is turned off or it may damage the antenna circuit. After
connecting to the power adapter and pressing the power switch, the device is turned on and starts working. The
initiation process can take up to 5 minutes depending on the type and number of sensors. The data can be viewed
on the cloud platform, as shown below: