User Manual

Table Of Contents

User Manual

Page 16 of 45

Unchecked: Device is in the normal working mode, the device starts normally and collects data, you can

view the device real-time operation log.

Checked: The configuration mode is activated, and various parameters can be configured after the

device is started.

③ To connect: after selecting the serial port number and checking the configuration mode, click "Connect".

After connecting, press the power button of the device, the "General Settings" and other functions will

light up, and the device can be configured.

④ Universal settings: Parameters such as device EUI (unique number for each device), server address, port,

data acquisition interval, etc. can be configured.

⑤ Sensor settings: you can add new sensors that support standard Modbus-RTU protocol.

⑥ Update Firmware: Upgrade the device.

Universal Settings

(1) Before the device is turned on, make sure the antenna SIM card are installed. When installing an antenna,

make sure the device is turned off or the antenna circuit may be damaged.

(2) Connect the device to the computer with the USB-to-TTL cable, access the Sensor Hub Configuration Tool,

select the serial port number, check "The device will automatically enter configuration mode after starting"

and click "Connect".

Tip: follow this path on your PC“Manage→ Control Panel→ Port”, and you can see the port number of the

device you are using.

(3) Press the power switch to turn on the device. After booting, the "General Settings" button will light up, and

the device’s information will be shown on the right side of the interface.