User Manual

User Manual

12 / 37

3) After the device is connected to the network, connect the Sensor Probe back with the Sensor Node

Controller by turning it clockwise. Please note that the labels on both parts should be aligned as shown

in the image below, otherwise the two parts will not be attached to function properly and data will not

be uploaded.

3.3.2 Sensor Node Working Status

You can refer to the LED indicator for the Sensor Node for its working status. Please see the status

explanations in the image below:

3.3.3 Connect to the Gateway (LPS8) and TTN Server

Typically, The LoRaWAN gateway needs to set the server address and uplink and downlink channel

parameters for the end device. Refer to the gateway user manual to configure the server. Here, a common

LoRaWAN Gateway (LPS8-915MHz) is taken as an example to explain how to configure the

communication parameters of the Sensor Node.