User Manual

SARK-110-ULM User’s Manual
Rev 1.0 June 22
th
, 2019 - 25 - © 2019, Melchor Varela – EA4FRB
«Setup – Units»
This setup allows configuration of distance units either in meters or feet.
«Setup – Points TDR»
Changes the number of sample points for Cable Test (TDR) function. Reducing the number of
points speeds up the scan speed but at the expenses of decreasing the resolution of the
measurements.
«Setup – Reset Factory»
This setup permits resetting the analyzer to its default settings.
The internal disk drive can be optionally formatted. Press the Enter [ ] button to format the disk
or any other button if only a reset to factory defaults is required.