Data Sheet

Example
Outdoor Sensor Device Power Supply
One important application of the Lipo Rider board is as an affordable power supply for outdoor sensors. The
outdoor sensor device will be powered by the lithium battery supplemented by the solar panel. Please note that
it is not recommended to run the outdoor sensor ONLY on solar power, as this may vary during the day and
may cause the sensor to reset / power down unexpectedly. In this case, the device is running in “USB Mode”.
If a firmware reprogram for the outdoor sensor device is required, simple connect the micro USB port to your
PC which will put the device under “Program Mode” as explained above.
Larger/multiple batteries and/or solar panels can be used, but only with end-user modifications.