Datasheet

35.8.2 Control B
Name: CTRLB
Offset: 0x04
Reset: 0x00000000
Property: PAC Write-Protection, Enable-Protected, Write-Synchronized
Bit 31 30 29 28 27 26 25 24
Access
Reset
Bit 23 22 21 20 19 18 17 16
RXEN
Access
R/W
Reset 0
Bit 15 14 13 12 11 10 9 8
AMODE[1:0] MSSEN SSDE
Access
R/W R/W R/W R/W
Reset 0 0 0 0
Bit 7 6 5 4 3 2 1 0
PLOADEN CHSIZE[2:0]
Access
R/W R/W R/W R/W
Reset 0 0 0 0
Bit 17 – RXEN Receiver Enable
Writing '0' to this bit will disable the SPI receiver immediately. The receive buffer will be flushed, data from
ongoing receptions will be lost and STATUS.BUFOVF will be cleared.
Writing '1' to CTRLB.RXEN when the SPI is disabled will set CTRLB.RXEN immediately. When the SPI is
enabled, CTRLB.RXEN will be cleared, SYNCBUSY.CTRLB will be set and remain set until the receiver is
enabled. When the receiver is enabled CTRLB.RXEN will read back as '1'.
Writing '1' to CTRLB.RXEN when the SPI is enabled will set SYNCBUSY.CTRLB, which will remain set
until the receiver is enabled, and CTRLB.RXEN will read back as '1'.
This bit is not enable-protected.
Value Description
0
The receiver is disabled or being enabled.
1
The receiver is enabled or it will be enabled when SPI is enabled.
Bits 15:14 – AMODE[1:0] Address Mode
These bits set the Slave Addressing mode when the frame format (CTRLA.FORM) with address is used.
They are unused in Master mode.
AMODE[1:0] Name Description
0x0 MASK ADDRMASK is used as a mask to the ADDR register
0x1 2_ADDRS The slave responds to the two unique addresses in ADDR and ADDRMASK
SAM D5x/E5x Family Data Sheet
SERCOM SPI – SERCOM Serial Peripheral Interface
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 989