Datasheet

When the receiver is disabled or the receive FIFO is full, the receiver will drive the RTS pin high. This
notifies the remote device to stop transfer after the ongoing transmission. Enabling and disabling the
receiver by writing to CTRLB.RXEN will set/clear the RTS pin after a synchronization delay. When the
receive FIFO goes full, RTS will be set immediately and the frame being received will be stored in the
Shift register until the receive FIFO is no longer full.
Figure 34-8. Receiver Behavior when Operating with Hardware Handshaking
RTS
Rx FIFO Full
RXD
RXEN
The current CTS Status is in the STATUS register (STATUS.CTS). Character transmission will start only if
STATUS.CTS=0. When CTS is set, the transmitter will complete the ongoing transmission and stop
transmitting.
Figure 34-9. Transmitter Behavior when Operating with Hardware Handshaking
CTS
TXD
34.6.3.3 IrDA Modulation and Demodulation
Transmission and reception can be encoded IrDA compliant up to 115.2 kb/s. IrDA modulation and
demodulation work in the following configuration:
• IrDA encoding enabled (CTRLB.ENC=1),
• Asynchronous mode (CTRLA.CMODE=0),
• and 16x sample rate (CTRLA.SAMPR[0]=0).
During transmission, each low bit is transmitted as a high pulse. The pulse width is 3/16 of the baud rate
period, as illustrated in the figure below.
Figure 34-10. IrDA Transmit Encoding
IrDA encoded TXD
TXD
1 baud clock
3/16 baud clock
The reception decoder has two main functions.
The first is to synchronize the incoming data to the IrDA baud rate counter. Synchronization is performed
at the start of each zero pulse.
The second main function is to decode incoming Rx data. If a pulse width meets the minimum length set
by configuration (RXPL.RXPL), it is accepted. When the baud rate counter reaches its middle value (1/2
bit length), it is transferred to the receiver.
Note: Note that the polarity of the transmitter and receiver are opposite: During transmission, a '0' bit is
transmitted as a '1' pulse. During reception, an accepted '0' pulse is received as a '0' bit.
Example: The figure below illustrates reception where RXPL.RXPL is set to 19. This
indicates that the pulse width should be at least 20 SE clock cycles. When using
BAUD=0xE666 or 160 SE cycles per bit, this corresponds to 2/16 baud clock as
SAM D5x/E5x Family Data Sheet
SERCOM USART - SERCOM Synchronous and Asyn...
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 932