Datasheet

25.8.6 Interrupt Flag Status and Clear
Name: INTFLAG
Offset: 0x10
Reset: 0x0000
Property: -
Bit 15 14 13 12 11 10 9 8
SEEWRC SEESOVF SEESFULL
Access
R/W R/W R/W
Reset 0 0 0
Bit 7 6 5 4 3 2 1 0
SUSP NVME ECCDE ECCSE LOCKE PROGE ADDRE DONE
Access
R/W R/W R R R/W R/W R/W R/W
Reset 0 0 0 0 0 0 0 0
Bit 10 – SEEWRC SEE Write Completed
• Unbuffered mode:
0: AHB write is pending.
1: AHB write has completed, and NVM is programmed with correct values.
• Buffered mode:
0: AHB write is pending.
1: AHB write has completed.
If SEESTAT.LOAD=0, then the NVM is programmed with correct values.
If SEESTAT.LOAD=1, then data is still pending in the Page Buffer.
Bit 9 – SEESOVF Active SEES Overflow
0: No SEES overflow have been detected since the last clear.
1: At least SEES overflow has been detected since the last clear.
This bit can be cleared by writing a one to its bit location.
Bit 8 – SEESFULL Active SEES Full
0: The active SEES is not full
1: The active SEES is Full, meaning that the next write will fail if the active sector is not reallocated.
This bit can be cleared by writing a one to its bit location.
Bit 7 – SUSP Suspended Write Or Erase Operation
0: No write/suspend has occurred since the last clear.
1: A write or erase operation has been suspended since the last clear.
This bit can be cleared by writing a one to its bit location.
Bit 6 – NVME NVM Error
0: No NVM errors have been received since the last clear.
1: At least one NVM error has occurred since the last clear.
This bit can be cleared by writing a one to its bit location.
SAM D5x/E5x Family Data Sheet
NVMCTRL – Nonvolatile Memory Controller
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 673