Datasheet

Incrementation for the source address of a block transfer is enabled by writing the Source Address
Incrementation Enable bit in the Block Transfer Control register (BTCTRL.SRCINC=1). The step size of
the incrementation is configurable and can be chosen by writing the Step Selection bit in the Block
Transfer Control register (BTCTRL.STEPSEL=1) and writing the desired step size in the Address
Increment Step Size bit group in the Block Transfer Control register (BTCTRL.STEPSIZE). If
BTCTRL.STEPSEL=0, the step size for the source incrementation will be the size of one beat.
When source address incrementation is configured (BTCTRL.SRCINC=1), SRCADDR is calculated as
follows:
If BTCTRL.STEPSEL=1:
SRCADDR = SRCADDR

+    + 1  2
STEPSIZE
If BTCTRL.STEPSEL=0:
SRCADDR = SRCADDR

+    + 1
• SRCADDR
START
is the source address of the first beat transfer in the block transfer
• BTCNT is the initial number of beats remaining in the block transfer
• BEATSIZE is the configured number of bytes in a beat
• STEPSIZE is the configured number of beats for each incrementation
The following figure shows an example where DMA channel 0 is configured to increment the source
address by one beat after each beat transfer (BTCTRL.SRCINC=1), and DMA channel 1 is configured to
increment the source address by two beats (BTCTRL.SRCINC=1, BTCTRL.STEPSEL=1, and
BTCTRL.STEPSIZE=0x1). As the destination address for both channels are peripherals, destination
incrementation is disabled (BTCTRL.DSTINC=0).
Figure 22-8. Source Address Increment
SRC Data Buffer
a
b
c
d
e
f
Incrementation for the destination address of a block transfer is enabled by setting the Destination
Address Incrementation Enable bit in the Block Transfer Control register (BTCTRL.DSTINC=1). The step
size of the incrementation is configurable by clearing BTCTRL.STEPSEL=0 and writing
BTCTRL.STEPSIZE to the desired step size. If BTCTRL.STEPSEL=1, the step size for the destination
incrementation will be the size of one beat.
When the destination address incrementation is configured (BTCTRL.DSTINC=1), DSTADDR must be
set and calculated as follows:
SAM D5x/E5x Family Data Sheet
DMAC – Direct Memory Access Controller
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 386