Datasheet

55. Electrical Characteristics at 105°C
The specifications for 105°C temperature devices are identical to those shown in 54. Electrical
Characteristics at 85°C, with the exception of the parameters listed in this chapter.
55.1 General Operating Ratings (105°C)
The device must operate within the ratings listed below in order for all other electrical characteristics and
typical characteristics of the device to be valid.
Table 55-1. General Operating Conditions
Symbol Description Min. Typ. Max. Units
T
A
Temperature range -40 25 105 °C
T
J
Junction temperature - - 125 °C
55.2 Supply Characteristics (105°C)
Table 55-2. Power Supply Current Requirement
Symbol Conditions Current Units
Max
I
input
Power-up Maximum Current 10 mA
Note: I
input
is the minimum requirement for the power supply connected to the device.
55.3 Power Consumption (105°C)
The values in this section are measured values of power consumption under the following conditions,
except where noted:
• Operating Conditions
– CPU is running on Flash with automatic wait state
– Low power cache enabled
– BOD33 is disabled
– I/Os are inactive input mode, with input trigger disabled
• Oscillators
– XOSC0 (crystal oscillator) running with external 32 MHz crystal
– XOSC32K (32 kHz crystal oscillator) running with external 32 kHz crystal in LP mode
– FDPLL is using XOSC32K as reference on LDO and external clock 32768 on Buck mode
– DFLL48M is using XOSC32K as reference
SAM D5x/E5x Family Data Sheet
Electrical Characteristics at 105°C
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 2035