Datasheet

...........continued
Symbol Description Min. Typ. Max. Units
T
A
Temperature range -40 25 85 °C
T
J
Junction temperature - - 105 °C
V
BAT
Battery Supply Voltage 1.71
(1)
3.3 3.63 V
Note:
1. With BOD33 disabled.
2. The same voltage must be applied to V
DDIO
and V
DDANA
. V
DDIOB
should be lower or equal to V
DDIO
/
V
DDANA
. The common voltage is referred to as V
DD
in the data sheet.
3. When I/O pads in the V
DDIOB
cluster are multiplexed as analog pads, V
DDANA
is used to power the
I/O. Using this configuration may result in an electrical conflict if the V
DDIOB
voltage is different from
that of V
DDIO
/ V
DDANA
. If the application has such requirements, it is required to power V
DDIOB
,
V
DDIO
and V
DDANA
from the same supply source to ensure that they are always at the same
voltage.
54.4 Injection Current
Stresses beyond those listed in the table below may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these or other conditions beyond those
indicated in the operational sections of this specification is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability.
Table 54-3. Injection Current
(1, 2)
Symbol Description min Typ. max Unit Comments
I
ICL
Input Low Injection Current -15 - - mA Note: 1, 4, 5
This Parameter applies to all pins.
I
ICH
Input High Injection Current - - 15 mA Note: 2, 3, 4, 5
This parameter applies to all pins, with the
exception of 5V tolerant pins.
∑I
ICT
Total Input Injection Current (Sum
of all I/O and control pins)
Absolute value of |∑I
ICT
|
- - 45 mA Absolute instantaneous sum of all ± input injection
currents from all I/O pins.
SAM D5x/E5x Family Data Sheet
Electrical Characteristics at 85°C
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 1987