Datasheet

(DRVCTRL.FILTERVALn). Therefore, the event detection is synchronous, and event action is delayed by
the selected digital filter value clock cycles.
When the Fault Detection on Debug Break Detection bit in Debug Control register (DGBCTRL.FDDBD) is
written to '1', a non-recoverable Debug Faults State and an interrupt (DFS) is generated when the system
goes in debug operation.
In RAMP2, RAMP2A, or DSBOTH operation, when the Lock Update bit in the Control B register is set by
writing CTRLBSET.LUPD=1 and the ramp index or counter direction changes, a non-recoverable Update
Fault State and the respective interrupt (UFS) are generated.
49.6.3.7 Time-Stamp Capture
This feature is enabled when the Capture Time Stamp (STAMP) Event Action in Event Control register
(EVCTRL.EVACT) is selected. The counter TOP value must be smaller than MAX.
When a capture event is detected, the COUNT value is copied into the corresponding Channel x
Compare/Capture Value (CCx) register. In case of an overflow, the MAX value is copied into the
corresponding CCx register.
When a valid captured value is present in the capture channel register, the corresponding Capture
Channel x Interrupt Flag (INTFLAG.MCx) is set.
The timer/counter can detect capture overflow of the input capture channels: When a new capture event
is detected while the Capture Channel interrupt flag (INTFLAG.MCx) is still set, the new time-stamp will
not be stored and INTFLAG.ERR will be set.
Figure 49-33. Time-Stamp
MAX
ZERO
COUNT
TOP
"capture"
"overflow"
Capture Events
CCx Value
COUNT COUNTTOP MAXCOUNT
49.6.3.8 Waveform Extension
Figure 49-34 shows a schematic diagram of actions of the four optional units that follow the recoverable
fault stage on a port pin pair: Output Matrix (OTMX), Dead-Time Insertion (DTI), SWAP and Pattern
Generation. The DTI and SWAP units can be seen as a four port pair slices:
• Slice 0 DTI0 / SWAP0 acting on port pins (WO[0], WO[WO_NUM/2 +0])
• Slice 1 DTI1 / SWAP1 acting on port pins (WO[1], WO[WO_NUM/2 +1])
And generally:
• Slice n DTIx / SWAPx acting on port pins (WO[x], WO[WO_NUM/2 +x])
SAM D5x/E5x Family Data Sheet
TCC – Timer/Counter for Control Applications
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 1828