Datasheet

Comparator interrupts are generated based on the conditions selected by the Interrupt Selection bit group
in the Comparator Control registers (COMPCTRLx.INTSEL). Window interrupts are generated based on
the conditions selected by the Window Interrupt Selection bit group in the Window Control register
(WINCTRL.WINTSEL[1:0]).
Each interrupt source has an interrupt flag associated with it. The interrupt flag in the Interrupt Flag Status
and Clear (INTFLAG) register is set when the interrupt condition occurs. Each interrupt can be
individually enabled by writing a one to the corresponding bit in the Interrupt Enable Set (INTENSET)
register, and disabled by writing a one to the corresponding bit in the Interrupt Enable Clear (INTENCLR)
register. An interrupt request is generated when the interrupt flag is set and the corresponding interrupt is
enabled. The interrupt request remains active until the interrupt flag is cleared, the interrupt is disabled, or
the AC is Reset. See INFLAG register for details on how to clear interrupt flags. All interrupt requests
from the peripheral are ORed together on system level to generate one combined interrupt request to the
NVIC. The user must read the INTFLAG register to determine which interrupt condition is present.
Note that interrupts must be globally enabled for interrupt requests to be generated.
Related Links
10.2 Nested Vector Interrupt Controller
46.6.12 Events
The AC can generate the following output events:
• Comparator (COMP0, COMP1): Generated as a copy of the comparator status
• Window (WIN0): Generated as a copy of the window inside/outside status
Writing a one to an Event Output bit in the Event Control Register (EVCTRL.xxEO) enables the
corresponding output event. Writing a zero to this bit disables the corresponding output event. Refer to
the Event System chapter for details on configuring the event system.
The AC can take the following action on an input event:
• Start comparison (START0, START1): Start a comparison.
Writing a one to an Event Input bit into the Event Control register (EVCTRL.COMPEIx) enables the
corresponding action on input event. Writing a zero to this bit disables the corresponding action on input
event. Note that if several events are connected to the AC, the enabled action will be taken on any of the
incoming events. Refer to the Event System chapter for details on configuring the event system.
When EVCTRL.COMPEIx is one, the event will start a comparison on COMPx after the start-up time
delay. In normal mode, each comparator responds to its corresponding input event independently. For a
pair of comparators in window mode, either comparator event will trigger a comparison on both
comparators simultaneously.
46.6.13 Sleep Mode Operation
The Run in Standby bits in the Comparator x Control registers (COMPCTRLx.RUNSTDBY) control the
behavior of the AC during standby sleep mode. Each RUNSTDBY bit controls one comparator. When the
bit is zero, the comparator is disabled during sleep, but maintains its current configuration. When the bit is
one, the comparator continues to operate during sleep. Note that when RUNSTDBY is zero, the analog
blocks are powered off for the lowest power consumption. This necessitates a start-up time delay when
the system returns from sleep.
For Window Mode operation, both comparators in a pair must have the same RUNSTDBY configuration.
SAM D5x/E5x Family Data Sheet
AC – Analog Comparators
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 1650