Datasheet

36.8.7 Status
Name: STATUS
Offset: 0x1A
Reset: 0x0000
Property: -
Bit 15 14 13 12 11 10 9 8
HS SEXTTOUT
Access
R/W R/W
Reset 0 0
Bit 7 6 5 4 3 2 1 0
CLKHOLD LOWTOUT SR DIR RXNACK COLL BUSERR
Access
R R/W R R R R/W R/W
Reset 0 0 0 0 0 0 0
Bit 10 – HS High-speed
This bit is set if the slave detects a START followed by a Master Code transmission.
Writing a '0' to this bit has no effect.
Writing a '1' to this bit will clear the status. However, this flag is automatically cleared when a STOP is
received.
Bit 9 – SEXTTOUT Slave SCL Low Extend Time-Out
This bit is set if a slave SCL low extend time-out occurs.
This bit is cleared automatically if responding to a new start condition with ACK or NACK (write 3 to
CTRLB.CMD) or when INTFLAG.AMATCH is cleared.
Writing a '0' to this bit has no effect.
Writing a '1' to this bit will clear the status.
Value Description
0
No SCL low extend time-out has occurred.
1
SCL low extend time-out has occurred.
Bit 7 – CLKHOLD Clock Hold
The slave Clock Hold bit (STATUS.CLKHOLD) is set when the slave is holding the SCL line low,
stretching the I2C clock. Software should consider this bit a read-only status flag that is set when
INTFLAG.DRDY or INTFLAG.AMATCH is set.
This bit is automatically cleared when the corresponding interrupt is also cleared.
Bit 6 – LOWTOUT SCL Low Time-out
This bit is set if an SCL low time-out occurs.
This bit is cleared automatically if responding to a new start condition with ACK or NACK (write 3 to
CTRLB.CMD) or when INTFLAG.AMATCH is cleared.
Writing a '0' to this bit has no effect.
Writing a '1' to this bit will clear the status.
Value Description
0
No SCL low time-out has occurred.
1
SCL low time-out has occurred.
SAM D5x/E5x Family Data Sheet
SERCOM I2C – Inter-Integrated Circuit
© 2019 Microchip Technology Inc.
Datasheet
DS60001507E-page 1040