Datasheet
Table Of Contents
- Spartan-7 FPGAs Data Sheet: DC and AC Switching Characteristics
- Introduction
- DC Characteristics
- Power-On/Off Power Supply Sequencing
- DC Input and Output Levels
- AC Switching Characteristics
- Performance Characteristics
- IOB Pad Input/Output/3-State
- I/O Standard Adjustment Measurement Methodology
- Input/Output Logic Switching Characteristics
- Input Serializer/Deserializer Switching Characteristics
- Output Serializer/Deserializer Switching Characteristics
- Input/Output Delay Switching Characteristics
- CLB Switching Characteristics
- CLB Distributed RAM Switching Characteristics (SLICEM Only)
- CLB Shift Register Switching Characteristics (SLICEM Only)
- Block RAM and FIFO Switching Characteristics
- DSP48E1 Switching Characteristics
- Clock Buffers and Networks
- MMCM Switching Characteristics
- PLL Switching Characteristics
- Device Pin-to-Pin Output Parameter Guidelines
- Device Pin-to-Pin Input Parameter Guidelines
- Additional Package Parameter Guidelines
- XADC Specifications
- Configuration Switching Characteristics
- eFUSE Programming Conditions
- References
- Revision History
- Please Read: Important Legal Notices
Spartan-7 FPGAs Data Sheet: DC and AC Switching Characteristics
DS189 (v1.9) March 13, 2019 www.xilinx.com
Product Specification 12
AC Switching Characteristics
All values represented in this data sheet are based on the speed specifications from the Vivado® Design
Suite as outlined in Table 12.
Switching characteristics are specified on a per-speed-grade basis and can be designated as Advance,
Preliminary, or Production. Each designation is defined as follows.
Advance Product Specification
These specifications are based on simulations only and are typically available soon after device design
specifications are frozen. Although speed grades with this designation are considered relatively stable and
conservative, some under-reporting might still occur.
Preliminary Product Specification
These specifications are based on complete ES (engineering sample) silicon characterization. Devices and
speed grades with this designation are intended to give a better indication of the expected performance
of production silicon. The probability of under-reporting delays is greatly reduced as compared to
Advance data.
Production Product Specification
These specifications are released once enough production silicon of a particular device family member has
been characterized to provide full correlation between specifications and devices over numerous
production lots. There is no under-reporting of delays, and customers receive formal notification of any
subsequent changes. Typically, the slowest speed grades transition to Production before faster speed
grades.
Testing of AC Switching Characteristics
Internal timing parameters are derived from measuring internal test patterns. All AC switching
characteristics are representative of worst-case supply voltage and junction temperature conditions.
For more specific, more precise, and worst-case guaranteed data, use the values reported by the static
timing analyzer and back-annotate to the simulation net list. Unless otherwise noted, values apply to all
Spartan-7 FPGAs.
Table 12: Speed Specification Version By Device
2018.2.1 Device
1.23 XC7S6, XC7S15, XC7S25, XC7S50, XC7S75, XC7S100
1.16 XA7S6, XA7S15, XA7S25, XA7S50, XA7S75, XA7S100
Send Feedback