User Manual
Table Of Contents
User Guide
©2008-2020 Seeed Technology Co., Ltd. All rights reserved. solution.seeedstudio.com
14 / 23
RESPONSE DELAY
Parameter range
0-255
Default:0
Parameter storage
Immediate storage
Serial communication delay response used in the following circumstances: when the host sends a
request command, delay module (RESPONSEDELAY*10 milliseconds), then the response data is
returned to the host. For example, to set up RESPONSEDELAY=5, so delay module 5*10=50
millisecond response requesting host. Set to 0 for no delay an immediate response. This command is
mainly used to host from RS485 transmission switch state to the receiving state relatively slow speed of
occasions.
ACTIVE OUTPUT INTERVAL
Parameter range
0-255
Default:0
Parameter storage
Immediate storage
Serial communication active output time interval used in the following circumstances: hosts that do not
need to send a request command module active output response data and output interval for
ACTIVEOUTPUTINTERVAL second, such as setting ACTIVEOUTPUTINTERVAL=5. So module every
5 seconds according to set up the communication protocol of a debate output data. Set to 0 when the
active output is invalid, the main request before response. This command is mainly used in GPRS
wireless transmission, terminal active node data transmission occasions.
Note: when the active output data is set, only one module can be connected on the RS485 bus.