User Guide
Table Of Contents
- Table of Contents
- 1 Product Introduction
- 2 Quick Start
- 3 Device Installation
- 4 Network Configuration
- 5 SenseCAP Portal
- 6 SenseCAP App Instructions
- 7 API Instruction
User Guide (Tech Document)
© 2008-2019 Seeed Technology Co., Ltd. All rights reserved. www.seeed.cc
17 / 50
Note: When installing the antenna, do not connect the power supply, otherwise it will cause damage to
the antenna circuit!
3.2.6 Installing LoRa Antenna
There are two kinds of LoRa antennas: the normal LoRa antenna (included in the package), and the
fiberglass LoRa antenna (to be purchased separately). The installation method for the normal LoRa
antenna is the same as that of the 4G antenna. Here we will introduce how to install the fiberglass LoRa
antenna.
1) Unscrew to remove the copper cap on the LoRa antenna port, and fasten the lightening arrester onto
the antenna port.
2) As shown in the image below, please fasten the fiberglass antenna onto the base part, and then fasten
the whole part onto the vertical cylinder (maximum cylinder diameter: 50mm).